Wood Veneer

Usually refers to the thin slice that is cut off from the log square, hence also called thin wood. Due to the wood from wood, so bring a variety of fine wood, wood for the types of wood texture, are associated with different kinds of wood and various cutting way the (such as oblique mountain lines, slitting and straight lines, etc.).

The veneer coating process of decorative line (commonly referred to as the skin) is the use of special coating adhesive to cover the surface of the line after the line is formed.

The advantage of decorative line using wood covering process.

1. Economic benefits. Only the veneer and the whole line are used in comparison with the original wood, saving the cost.

2. It has natural and beautiful wood grain, and has the same gentle touch as the log.

3. Save wood resources. Cladding process line, base material can be density board, laminated, or fir uniform timber, and even other material such as aluminium, wood and plastic, so to some extent, save the wood resources of slow growth, especially the wood grain of rare and precious wood.

With regard to the line that USES wood skin to wrap, the client often raises several request erroneous zone.

1. The thickness of wood is not as thick as possible.

Lines are alien, the surface has a wide variety of concave and convex shape, wood veneer in the process of coating must be with the whole line of concave and convex structure and perfect fit, and the material of wood, wood has certain brittleness, if too thick wood veneer, does not have operability in the coating process, in particular the 90 degree Angle position, thicker wood veneer can split directly. The wooden skin that is used on adornment line is reasonable thickness should be inside 50 silk, to some of the line that has relatively complex modelling, wood skin thickness should be inside 30 silk is appropriate.

2. The line of wood covering process cannot be used for surface treatment such as drawing.

We noted above the line coating use within 30 silk more wood veneer, the thickness if forced drawing, the result is that pull wood to wear and show lines under the wood base material, therefore, only by do after wood coating open paint to make antique effect such as line surface as far as possible close to the drawing.

3. About PUR hot glue coating and wood skin finger joints.

The high quality of PUR hot glue can not be required, and the existence of the interface is not allowed. PUR hot melt adhesive coating is a kind of irreversible moisture reactive cladding process, the more resistant to high temperature and low temperature than the ordinary hot melt adhesive, has better stability, and therefore become more and more popular (about PUR hot glue coating process, after string cable will be to introduce alone). But the hot glue coating equipment requirements cladding material supply must have continuity, separate into a wood veneer must therefore refers to can be used only by continuous roll shape, and therefore also refer to joint became an inevitable exist.